Adjusting IgnitionCounter

Resolving problems with software and hardware

Модератор: DanMc85

Ответить
lotushiast
Сообщения: 5
Зарегистрирован: 14 июн 2018, 19:16

Adjusting IgnitionCounter

Сообщение lotushiast »

Hello, after flashing the PCM the ignition counter is 0.
Is it possible to adjust tis value?
Thanks.

pyzo
Сообщения: 6
Зарегистрирован: 22 июл 2018, 19:39

Re: Adjusting IgnitionCounter

Сообщение pyzo »

HI

This is the parameter in PCM - would be great if the developer would enable this to write it with UCDS
M9_08_IGNCNTR_A
M9_08_IGNCNTR_B

Extraction from Ford Instruction:

Section B: Determining the Existence of an Aftermarket Calibration
This section should be used when the vehicle being serviced currently has or possibly had an aftermarket PCM calibration. It is recommended to also conduct this step on tow in vehicles with unexplained engine damage.
B.1 Ignition Counter
1. Pull Mode 9 data with IDS
Capture.JPG
2 Compare ignition counter (IGNCNTR) value to vehicle service history. If counter value is abnormally low and there is no history of a recent reflash, investigate for an unauthorized reflash and signs of aftermarket tuner connections. Refer to Chart 1.
У вас нет необходимых прав для просмотра вложений в этом сообщении.

Johoo
Сообщения: 10
Зарегистрирован: 24 ноя 2016, 09:57

Re: Adjusting IgnitionCounter

Сообщение Johoo »

Is this already possible?

Developers are investigating this if this will be possible?

cantonat
Сообщения: 1
Зарегистрирован: 07 ноя 2020, 22:49

Re: Adjusting IgnitionCounter

Сообщение cantonat »

Any Update on this? Especially for Focus MK3?!

BR.

Ответить