Страница 1 из 1

Faults after updating modules with UCDS

Добавлено: 09 янв 2020, 21:46
xnm374
Hello, I'm new here.
I recently updated all the modules on my 2017 ranger using the update wizard.
Since then I have faults in the BCM and RCM

The fault is B11D8 crash event occurred.

Can somebody please help me resolve this, Thanks. Jo

Re: Faults after updating modules with UCDS

Добавлено: 10 янв 2020, 00:26
silvercircle
Change the value in the direct config from true to false.

Re: Faults after updating modules with UCDS

Добавлено: 10 янв 2020, 14:32
xnm374
I cannot find this option

Re: Faults after updating modules with UCDS

Добавлено: 13 янв 2020, 00:29
silvercircle
start ucds, start direkt configuration, take your modell an open the bcm contol unit read from car then take a look an alle parameters. by an Focus ist the chrash parameter Nr. 35 or so. by other modells ??? make the same in the other control unit.

Re: Faults after updating modules with UCDS

Добавлено: 14 янв 2020, 12:15
xnm374
That option isn’t visible in the ranger bcm

Re: Faults after updating modules with UCDS

Добавлено: 14 янв 2020, 22:16
silvercircle
when i start my ucds, i find in direct config, bcm (FU5T-) under point 115 Alarms 01 DE 00 "crash enable cfg (disabled) and underneth crash spinout ... there gives 3 different types of bcm modules they are build in a ranger, you must try which one is the correct one and search. i dont know whether it is correct but ucds has is no manual, you can only try.

Re: Faults after updating modules with UCDS

Добавлено: 21 янв 2020, 13:17
xnm374
Hello, thanks for the reply. I have tried this and still no luck.

Re: Faults after updating modules with UCDS

Добавлено: 21 янв 2020, 22:51
silvercircle
have you tried to clear crash data in normal mode ? you take the picture from ranger and go to the special procedures. here is a point to clear all faults in register rcm.

Re: Faults after updating modules with UCDS

Добавлено: 29 янв 2020, 18:32
xnm374
Yes I have tried that, running out of things to try now

Re: Faults after updating modules with UCDS

Добавлено: 30 янв 2020, 16:14
xnm374
Fixed, many thanks to darkleo! He reverted software back to before update!