Страница 1 из 1

Display dead - help needed

Добавлено: 18 янв 2020, 13:00
gregd72002
Hi,

I am trying to do force programming on a dead IPC. HW part: BK2T-14C226-BB
It is from Ford Transit Custom 2014 but they should be the same as in Focus or Mondeo. It has UPD70F3425GJ(A) chip from Renesas.

I am able to program an SBL to it using recovery in FoCCCus, so I know that the IPC is communicating. FoCCCus does not allow me to program the actual IPC software though.
SBLs I tried:
BM5T-14C025-BD
BK3T-14C025-BA
BK3T-14C025-AA

But in UCDSYS I am not able to program any VBF to it. Neither SBL. When using Forced programming UCDSYS waits for the first communication from the IPC. After plugging power to IPC I can see the adapter communicating with it as the diodes on adapter blink for a second.
The programming stops then immediately and nothing happens. I can press "Start Programming" again and have the same outcome all the time.

What should I try?
Is UCDSYS able to recover newer IPCs?
It looks to me like the SEED might be invalid but why FoCCCus can write SBL?

Attaching an old picture of my IPC for reference. Now it does not turn on.

Re: Display dead - help needed

Добавлено: 18 янв 2020, 23:33
gregd72002
Resolved. It looks like there is a problem with "Forced programming" in the last UCDSYS version. I was able to program dead module using Update Wizard and switching on power to the IPC in the right moment after clicking "Start Programming". It took quite a few attempts but eventually succeeded.

Update: Every time I use VBF Loader it renders the module dead. Even if I try to flash the same VBF as used in Update Wizard. Must be something wrong in the last UCDSYS version 2.0.7.003. VBF Loader worked in previous versions.

Re: Display dead - help needed

Добавлено: 12 фев 2020, 23:51
silverstreak2006
I wonder if termination (or lack of) causes this. I have a dead IPC, replaced and updated. Would be nice to revive the old one.