Hi, i have a problem after updating the IPC.
I coud'nt load the Asbult file from ETIS or the original backup file.
A message occures access denied x errors!
So i open the update wizard and see this: ecu software #2 part F120 NRC conditions are not correct.
Any thoughts?
Thanks!!
IPC not correct after update
Модератор: DanMc85
-
- Сообщения: 8
- Зарегистрирован: 14 июн 2018, 19:16
IPC not correct after update
У вас нет необходимых прав для просмотра вложений в этом сообщении.
-
- Сообщения: 14
- Зарегистрирован: 05 янв 2020, 15:32
Re: IPC not correct after update
You can probably force the files again, then re-update. Are you making config changes after?
-
- Сообщения: 8
- Зарегистрирован: 14 июн 2018, 19:16
Re: IPC not correct after update
Thanks, will try it again. Made no changes after,