UCDS Forum

kroligoff писал(а):Hi,
1. Ok, Asbuilt is original on vehicle or modifed before? You read first and vehicle have parameter 150, before you modifications?

2. Now this vehicle set 163ps?

Hi Kroligoff,

First: i read all dtcs with forscan, and i have only error in the ipc module
Second: I make a backup with ucds and with elmconfig of the bcm.

Third: I read the configuration with the ucds software:
After, i change the engine type to 2.0 DW10C CR14 150PS Stage V, and write configuration.

After i go to Kuga2, to the label PCM Reprograming, and check CCC Laerning Diesel in PCM SPecial Procedures

To Finish i go to smax label, to dtcs, read all modules and reset all modules. And i make the same with forscan.

And then this error appear:
If i read the configuration the engine type is the last, 2.0 DW10C 150PS.

I change engine type to 136/140 but the error remains.

At the end i return the engine type to 140 CV

You modifed asbuilt from Mondeo section? What you do not follow instructions?
WRITE and MODIFY ASBUILT ONLY FROM ASBUILT EDITOR SECTION!!! And Please try write original Asbuilt (Download from Etis)

rmcgry писал(а):

2015-04-19 15.41.02.jpg

One questions, for make this test i will go to run in the car and with laptop connected???

Because if i have the engine turn on i have only about 55-65 NM.
Then i need run to the car and save the sessions in the forscan? Or how i need make the measurement?

Thanks.

Yes, connected and driving.

rmcgry писал(а):Yes, connected and driving.

Ok, thanks, i will test more later, but in my car to test it! In the other car that i make the changes until this weekend i will can´t!

OK, let us know the outcome please

Hi, i test it now, when i return from my job to my house.

421 is too much

how much was in 140PS?

Different car i think.....

mayak писал(а):421 is too much

how much was in 140PS?

This values are from my car, smax 163cv powershift remaped.

This weekend i Think that i can make this test in the car Of My friend.

phoenix241 писал(а):
This weekend i Think that i can make this test in the car Of My friend.

Wait for information

thanks

Any news about this error in WIndows 8.1???

Sorry for this issue, on next version i disable halt application ,show only warring message.
You Upgrade system from 8 to 8.1, use hyper-v ?
please run msinfo32 and search hyper-v