UCDS Forum

Hi guys

Is it possible to update the 2.0 diesel from 150 hp to 180 hp? 2018 model S-max.
If it is possible how do i do it? anybody has a small guide?
Know that I need credit for could do it.

Best regards
Lars

I am also seeking this exact same solution for a 2016 2.0tdci kuga

For S-Max:
Direct Configuration => Mondeo [CD391] 2014 => PCM 2.0D => 23: Config Data - DE00 => Engine (28)
- set it to "2.0L DW10F (Power Rating 3)
Direct Configuration => Mondeo [CD391] 2014 => ABS (F2GC-* SMAX) => 7: ECUConfig - DE01 => Suspension, Engine-Type (1)
- set it from 150HP to 180HP

Do a modul reset of both moduls

And why do u need to set ABS to 180?

Thanks!

Maybe abs needs to know power output to do correct calculations to stop from expected higher acceleration?

How to reset modules?

Thanks!

Hello lads. I just did as per instructions above on a 2016 Mondeo 2.0 tdci. I used abritues to reset the modules. Car starts fine.

What did u use?

Ucds and abritus

And how to reset the modules in UCDS?

Go to "Mondeo 5/...", in "DTCs/Poll Modules" right click on PCM, choose "Reset Module"

Already done!

Set the ABS to 180HP and gave the ABS a reset.

But thanks!

and so easy u can have a 180PS car?

same possible with a focus 2011 ?

Do you know if the same procedure can be used in Ecoboost 2.0? Is it that easy?
Thanks.

I guess u need to flash other firmware for those