UCDS Forum

У меня есть Ford Mondeo 2008 Я хочу сменить приборную панель автомобиля, теперь она с моделью 6M2T 10849 CP, и я хочу заменить ее этой моделью AM2T 10849 VC, которая CONVERS +, но, разместив ее и постоянно зажечь аэрограф и запустив ошибки в компьютере автомобиля, поможет, если вы знаете, как я могу справиться с этим очень сильно. Я хочу поставить свою новую панель усиления на автомобиль

Please write on russian, on russian i do not understand

I have a Ford Mondeo 2008 I want to change the instrument panel of the car now with a model 6M2T 10849 CP and I want to replace it with this model AM2T 10849 VC but by putting it on and flashing an airbrush and starting to make mistakes in the computer of the car help how can to fix a lot I want to put my new instrument panel on the car

Need install special firmware "Motral Convers+" and choose "installed on older car"

where to download this file and what kind of program I need to upload it and can you upload with elm327 cable

kroligoff писал(а):Need install special firmware "Motral Convers+" and choose "installed on older car"

in my opinion not ... AM2T 10849 VC is between prefacelift and facelift (fw version 11xx) ... you cannot upload 14xx into it

koster писал(а):where to download this file and what kind of program I need to upload it and can you upload with elm327 cable

free sw for upload does not exist

and is there how to restart CONVERS+
because I put it now CONVERS+ in my car lights an airbag and does not go out

To change the firmware in IPC (convers +) via elm, try:

• conversmod •

it is not solution for user koster