How to activate Sync 3 video input
Добавлено: 28 фев 2020, 18:39
I am working on a front camera on Sync 3 module on my Mondeo MK5.
When you switch into Rear gear, the rear view camera is shown on the screen, when you switch to neutral, you see the normal Sync screen again.
What command must be send to the Sync3 (APIM) to switch to its video input (pin 14,15) and back ?
Can we sent this command in UCDS under "additional functions" "CanBusMonitor" "Sent to CAN" to test this ?
When you switch into Rear gear, the rear view camera is shown on the screen, when you switch to neutral, you see the normal Sync screen again.
What command must be send to the Sync3 (APIM) to switch to its video input (pin 14,15) and back ?
Can we sent this command in UCDS under "additional functions" "CanBusMonitor" "Sent to CAN" to test this ?