UCDS Forum

Hi, i try change power rating from 150HP at 180HP in Focus 3 and C-max engine its a diesel 2.0 i changed ccc configuration engine at 180HP but all cars hawe same problem dont work automated park asistance if HP i changed to 180HP some-bady hawe idea why? I see DTC errors in APIM and PSCM "lastes configuration not finished" sorry for broken english. CCC readed from BCM and writed in BCM need doit same in PCM ? CCC learn in special procedures in PCM dont eliminate this problem.

Hmm never seen this error, you only make As bulit config or dircet config?

You DTC not related with power rating, load from etis in APIM configuration or make correct changes (see wiki if Sync3 upgraded)

In direct Conf change is set to power rating 3 like in wiki but driver told me i dont see diference if i change ccc conf in BCM him see diference more power more torque but dont work parking asisstance. Yes Kroligoff Sync 3 conf its ok all configured like in wiki . Problem is in other side, wiki sugestion to change direct conf. in PCM dont make felling changes in engine. But select 180HP engine in CCC in bcm configuration doit this diference, its only one problem don work automated park assistance, i looked in all places some error but i dont se nothing wrong PAM its configured well, and have DTC in PSCM U2100 and same in HAVC if i return configuration at 150HP in BCM all its normal and work but no 180HP. This solution in direct conf change power rating form 2 in 3 dont make more power.

After need make init in ABS , see wiki

Yes ABS its initilized no icon in IPC all work .

larsmdk писал(а): ↑31 май 2020, 23:00 Hmm never seen this error, you only make As bulit config or dircet config?

You Think its this problem ? if its configured in As built and direct conf? only direct conf dont make more power

Is the problem with the automatic parking solved?

I want to order the UCDS-adapter to turn my 2.0 tdci from 150hp to 180hp... But I don't want to disable the automatic parking.

Thank you for infos