Ford Ranger BCM

[Artos1974]

Need help!!!

I need the VBF files for the BCM !!!
Have 2 DTC I can not delete!

BdyCM U2100:00-8A
BdyCM U2101:00-0A


Ask for your help

[kroligoff]

SBL:DG9T-14C187-AB
#1:HU5T-14C184-AAN
#2:EB3T-14C636-AAA
#3:EB3T-14F389-CA
#4:EB3T-14F390-BAB
#5:EB3T-14G163-AAA
#6:HU5T-14F391-AAA
#7:HU5T-14G162-CAC

Try load direct config to BCM from etis

[Artos1974]

Thanks for the files!
Did it with the VBF Loader ind wrote the modules, have used HS1 for it! Have then recorded the direct config of ETIS ..
I programmed the TPMS sensors with the teach-in unit.
The 2 errors are still there and can not be deleted.
and the interior lighting continues to flash!

[zrachwal84]

I got the same problem in Mustang

Very strange problem

[saeb]

Hate to say it but there is one change you have made to the asbuilt in the past that has brought on these faults.

Only way I know of at this stage is the replace the BCM. No amount of flashing, re doing PATS etc. removes the fault.

Spent numerous days and hours with UCDS, local Ford dealer using their security access etc which still did not resolve the issue.

When did the issue appear and what changes did you make to bring it on?

[kroligoff]

Please open in Data Logger BCM,
Read EE04 Control Module Configuration Fault
and provide information about

[saeb]

EE04 for my old BCM I have on the bench is Zero.

Most of the faults that the above user has experienced are from changing DE15 "slaveexist SCL Cfg" from disable to enable. Once enabled it cannot be disabled again and will give the configuration error and flashing interior light.

[_pucek112]

EE04 for my old BCM I have on the bench is Zero.

Most of the faults that the above user has experienced are from changing DE15 "slaveexist SCL Cfg" from disable to enable. Once enabled it cannot be disabled again and will give the configuration error and flashing interior light.

Hi
Do you know the SCL Cfg slaveexist repair procedurę. How to disable??

[Tomi1]

Hello

has anyone found a solution to this problem?

[Ranger2016]

EE04 for my old BCM I have on the bench is Zero.

Most of the faults that the above user has experienced are from changing DE15 "slaveexist SCL Cfg" from disable to enable. Once enabled it cannot be disabled again and will give the configuration error and flashing interior light.

How do you bench it ?

[kroligoff]

Need reset BCM to Manufacture mode, please contact with telegram @xJustHunteRx for do it

[maniutek]

Hey
Has anyone found a solution to this problem?

[Ranger2016]

you have to remove the bcm and factory reset it on the table. there are few people who can do that. But it works